Custom Slotted Round Metric Screws - M7 X 1.0 X 34.5MM In Mild Steel With Black Oxide

These custom slotted round metric screws were manufactured using a cold heading process mild steel material, finished with a black oxide treatment. 90-92 degree angle was incorporated underneath the head, which had an outside diameter of 13.37MM-13.80MM and overall height of 5.15MM max inclusive of the undercut portion. Full M7 X 1.0M thread was rolled to a 6G thread fit. The slotted drive was designed to 1.81MM-2.06MM width and depth of 2.5MM at minimum. Our internal part number for this custom metric machine screw is MMSO-07035-F.

Custom Cone Point Screws - 8-32 Slotted Machine Screw In 18-8 Stainless Steel

These custom cone point screws were manufactured using 304 stainless steel material with plain finish.  8-32 fine thread was incorporated with the overall length of the threaded portion and the cone point set at .2925"-.3125".  The head diameter was .306"-.322" and slot depth at .045"-.058".  Head height was set at .085"-.096".  Production was completed at just over 13,000 pieces within 8 weeks from order.

Custom Long 316 Stainless Steel Screws - 8-32 X 3 Socket Head Cap Screws

These are custom long 316 stainless steel screws at 8-32 X 3 in dimensions, manufactured domestically at a small batch of approximately 40 pieces.  The parts were completed in a relatively quick turnaround time-frame of approximately 4 weeks from order, especially considering the holiday timing.  To allow for the small quantity and speed the hex socket drive was broached instead of using a cold headed approach.  You can see evidence of this at the inside of the recess drive where you would see machining marks instead of the typical clean concave interior seen in cold headed parts.  The partial thread was also cut rather than rolled to allow for the short production run option.