Custom Low Profile Socket Head Screws - 302 Stainless Steel With 6 Lobe Drive

These custom low profile socket head screws with a  6-lobe (torx) drive were manufactured domestically using 302 stainless steel material with a commercial passivated plain finish.  5,000 pieces of two sizes were produced: M10 - 1.5M X 65MM with a T-45 drive size and M8 - 1.25M X 65MM with a T-30 drive size.  26-30MM of thread was incorporated on the larger version and 22-25MM on the smaller diameter part.  The low profile & 6-lobe drive combination is relatively tricky, especially for these larger diameters as additional controls in tooling are required to avoid flowering on the outside profile of the head.

Custom Galvanized Anchor Bolts - A36 Steel, Galvanized

These custom galvanized anchor bolts were manufactured domestically with a rush timeline using A36 steel material with a galvanized finish.  7 inches of 1"-8 coarse thread was incorporate on the long leg, with cut thread as opposed to a rolled alternative.  Overall length was set at 17" and the length of the short leg on the outside is 3".  Two galvanized nuts and washers were supplied per anchor bolt.