Our customer requested these light brown painted button socket screws in batches of approximately 2,500 pcs of both the security screw version and the standard button socket version. Pin-in button socket drive was used for the security screw and both parts measured 6-32 X 5/16. Alloy steel with thermal black oxide was used for the base part material, and the security screws had a wax coating that required stripping prior to the paint application. Painting the screws without this stripping process would result in a good looking part until you actually tried to use them, at which point the paint easily chips and peels off the surface. Unfortunately it's often difficult to discern whether the part has this wax coating or not, requiring a sample test run to be sure.
These custom bent eye bolts were produced together with matching large round u-bolts in A36 material. 3/4-10 thread was incorporated on both parts and 6 eye bolts were produced together with 21 u-bolts, a relatively small production run. Parts were produced within 4 days of order confirmation but could have been done faster with an expedited rush order and fee if necessary. The diameter of the eye was set to 1-1/2" and the thread length was set to 2-1/2". We were approx 1/4" shy of the thread length requested however as going beyond that would encroach onto the bending material. The round u-bolts were made to 3-1/2" between the legs and 4" for the inside length. 1" of 3/4-10 thread was incorporated on each leg.