Custom 302 Stainless Steel Narrow Washer

This washer is a very similar part to the other narrow 304 stainless steel flat washer posted some days ago.  It is made in the USA using 302 stainless steel in quantities of 1,000-1,500 pieces at a time and carries an approximate 4 week lead time.  The dimensions are as follows: ID of .7180, OD of .9680, and Thickness of .0630.

Special Grade 5 Hex Head Shoulder Bolt

This is a special grade 5 hex head shoulder bolt made in the USA and finished with commercial zinc with bake and clear chromate sealant.  The bolt measures 5/16-18 X 1-1/4 and is supplier on an annual blanket order basis to our US based customer.

Special Flat Washer in 304 Series Stainless Steel

We supply our diverse customer base countless special made flat washers, mostly on blanket as-released purchase order basis.  This is a custom 304 stainless steel flat washer made in the USA to an inside diameter of .600, outside diameter of .872, and thickness of .047 inches.

Special Phillips/Slotted Hex Washer Head Machine Screw

This is a part we supply our long time customer on an as-needed basis every two years or so at approximately 40,000 pieces per order.  It is a M4-0.70 X 9.5MM phillips slotted combo drive hex washer head machine screw made using steel material with black oxide and light oil per customer specifications.  Made in the USA this part typically carries a 5-6 week lead time from order.

Special U-Bolts In Stainless Steel Material

We have been supplying a diverse range of custom U-bolts to the construction, plumbing, and HVAC industry for over 20 years.  This is a custom 3/8 diameter 304 stainless steel U-bolt at 6-3/4 inch inside width, 7-7/8 inch depth and approximately 2-1/2 inches of coarse thread.  Lead time for parts like this varies based on material, size, and quantity but is typically between 3-5 days from order.

Special Thread Cutting Screw With Type 17 Point

Custom thread rolling and thread cutting screws are the most common types of special parts we supply - this is a custom #10-12 X 1" phillips square combo drive thread cutting screw made in the USA using 302 stainless steel.  A type 17 point is incorporated to our customer's specifications and the parts are run through a black oxide and wax service as a final step.  These parts are stocked and releases on a blanket purchase order basis annually.