Search Our Custom Fasteners
Tuesday, February 15, 2022
Custom Metric Shoulder Bolts - 304 Stainless Steel
These custom metric shoulder bolts were manufactured using 304 stainless steel material with the head cold formed and shoulder machined to a diameter of 11.965-11.938mm by 80mm in length, with 16mm of M10 X 1.5 6g thread after the relief. The knurled socket head incorporated a 6MM hex socket drive. Material certs and a certificate of conformance was provided with the parts.
Labels:
custom stainless shoulder bolts,
custom stainless shoulder screw factories,
stainless metric shoulder bolt manufacturers,
stainless metric shoulder screw manufacturers
Location:
Chicago, IL, USA
Custom Slotted Pins - DFARS Stainless Steel
We had these custom slotted pins manufactured domestically for our aerospace customer using DFARS compliant 303 stainless steel material. The pins measure .094" in diameter and .35" in overall length, with the slot at .020" in width by .115" in depth. The outside profile tapered from .094" diameter max to .088" at the narrow side. Full certs were provided with the parts.
Labels:
custom slotted dowel pin manufacturers,
custom slotted pin factories,
custom slotted pins,
custom stainless slotted pins,
stainless steel pin manufacturers
Location:
Rancho Cucamonga, CA, USA
Custom Flat Stamped Nuts - M8-1.25 Thread
We had slightly over 10,000 pieces of the custom flat stamped nuts manufactured using mild steel material with zinc clear finish. Outside dimensions measured 22.86mm X 16mm with thickness set to 6mm. M8-1.25 6h thread was tapped with its center approximately 5.6mm from the edge of the nut. 6mm is probably the maximum thickness to allow stamping for this size nut without exhibiting too much variation in thickness along the profile.
Labels:
custom flat stamped nuts,
custom lock nut manufacturers,
custom metric nut factories,
custom metric nut manufacturers,
custom offset nut factories,
custom offset nuts
Location:
Chicago, IL, USA
Subscribe to:
Posts (Atom)