Custom Long Stainless Steel Dowel Pins - 303 Stainless Steel

 

These custom long stainless steel dowel pins were manufacture domestically using 303 stainless steel material.  The diameter was set to 2.002mm to 2.008mm and the length was set to 100mm +/-.01mm.  Full certs were provided with the parts and thorough QC testing was done on the straightness.

Custom Threaded Stainless Pins - M3 & 10-32 Thread

These are tiered custom threaded stainless pins created for an audio equipment manufacturer in 18-8 stainless steel material.  Production was done domestically with a lead time of 5-6 weeks from order.  The overall length of the part is at 1.4" inclusive of .90" of M3 coarse thread and .37" of 10-32 thread.  Multiple shoulder steps were incorporated per our customer's specifications and the drive-less head measures .50" for the OD and .066" for the height.  The next iteration of this part will likely incorporate a thicker head and a slotted drive.

Custom Stainless Slotted Pins in 416 Stainless Steel Material - RC 26 to 32

We supplied our long time medical device customer 2,500 pieces of these tricky custom stainless slotted pins.  Production was done domestically using 416 stainless steel material - the original design called out for 17-4PH stainless steel material but that was found to be unnecessary for the relatively simple application.  416 SS provided a much more cost effective and faster alternative while still providing the "spring" action required when the four petals were contracted.  10 pieces were provided out of the production batch for testing and approval before the balance was completed with the slotting process.

Custom Slotted Pins With Partial 6-32 Thread - 304 Stainless Steel Material

We supplied our customer a short run supply of these custom slotted pins with partial 6-32 thread.  Just over 200 pieces were produced domestically using 304 stainless steel material.  The 6-32 thread length was set at 0.18" and all other dimensions were derived from the samples our customer provided us.  These parts were relatively simple without any special services or paperwork requirements.

Custom Stainless Steel Precision Pins - 303 Stainless Per AMS 5640 V Type 1

220 pieces of these custom stainless steel precision pins were produced domestically for our aerospace customer using 303 stainless steel material.  Original specifications on the drawing called out for 303 stainless steel per AMS 5638 but we obtained a deviation approval to provide the part using a similar AMS 5640 V Type 1A spec material instead.  Passivation per AMS 2700, method 1, type 4, class 2 was done to complete the parts prior to QC inspection.  Overall length measures at 1.131" +/-.005 and the shaft diameter is set to .074-.075".  The width of the flattened section on one end reaches a diameter of .084" +/- .005.  The other end is rounded at R .078.

Precision Custom Stainless Steel Dowel Pins - .1160 X .625 Made to Customer's Drawing

This is a small batch of custom stainless steel dowel pins manufactured domestically in the USA at just 36 pieces.  303 stainless steel was used and the custom dowel pins measure .1160 at the diameter by .625 inches in length.  The diameter was the most critical dimension with a tolerance of +/-.0001".  Both sides were chamfered at .010 X 45 degrees and +/-.005 tolerance was called for on the length.  We were able to get production completed and parts shipped in less than 2 weeks from order confirmation.

Special Dowel Pin to Print In 303 Stainless Steel

We supply a wide range of special pins in materials varying from PVDF to 303 stainless steel like these special to print 3/16 X 7/16 dowel pins.  This pin has been provided to our customer using the same trusted factory for over five years.